Hi, does anyone know of a spot to run wiring from the engine bay through to the inside of the car ?
As I am putting new Led spot lights on the front of the car.
I have not seen anywhere in the engine bay where wiring goes through to the inside of the car.

Do the flip top bonnet thing, then under the brake fluid reservoir you will see a big rubber grommet with loads of wires going into the cab behind the steering wheel...

There is one the other side behind the battery but not as easy to get to...

 Pete

__________________________________________________
2014 L405 Autobiography SDV8 4.4 Loire Blue Ebony interior
2011 L322 Vogue SE 4.4 TDV8 Baltic Blue. Parchment over Navy Interior. Sold
2012 L322 Autobiography 5.0 Supercharged Ipanema Sand, Jet Interior. Sold
2002 L322 Vogue 4.4 V8 Epson Green, Ivory over Aspen Interior (Fatty Offroader) Sold
-Click for Project Fatty off roader-

as Pete says, thats if yours has the same config as the L322..

stick a screwdriver to the side of the wires through the grommet and pass the wire through the hole.. ... - .- -.




click link for ,

FORUM WIKI

HOW TO Ǝꓕ∀ꓕOꓤ PICS

workshop manual downloads are in our wiki

.

Sorry, didn't see it was a 405.... I expect there is something similar as the 322...  Pete

__________________________________________________
2014 L405 Autobiography SDV8 4.4 Loire Blue Ebony interior
2011 L322 Vogue SE 4.4 TDV8 Baltic Blue. Parchment over Navy Interior. Sold
2012 L322 Autobiography 5.0 Supercharged Ipanema Sand, Jet Interior. Sold
2002 L322 Vogue 4.4 V8 Epson Green, Ivory over Aspen Interior (Fatty Offroader) Sold
-Click for Project Fatty off roader-

Hi guys thanks for trying to help me !
I removed R/H side cover over brake fluid tank and brake booster, i could see the wiring, however it disappears down towards the centre of the car under the steering column , I think going under the steering from inside the car you would see this wiring coming through the panel in the car is easy to remove. But I think you would need wire to feed through from inside then try and grab it from brake booster area, then attach electrical wiring for the Led lights to this lead wire you fed through and pull through led light wiring from the inside of the car to the engine bay area.
I dont think this would be easy to do but it could be done.

So I when for the remote control option for the Led lights, and ran the power wiring for these lights from off the engine bay jump start terminals.
The negative terminal just unscrews and placed the wiring connector under it. Then the positive terminal I just unscrewed the box it was in on one side and the other side of the box is held down with a push in clip that with screw driver leaver it just pops out of the hole, then it is an easy job to attach the positive power wire under the nut that holds the positive jump start terminal.
Then it just routing the Led wiring to the front of the car for the Led lights and tying up all the wiring under the bonnet.

So now I just push the remote and hey presto they work