I have been given a set of Kahn alloys which cam off an 06 vogue. My nuts off my 05 vogue do not fit so I bought a set of 06 onwards and guess what they don't fit either. The problem is that the shank is too big on both sets of nuts and when I put the wheels on there is very little room for the shank of a nut. Anybody had this problem. I am trying to get to see the motor they came off and measure one of the nuts but as yet have not been able to do it. Anybody any suggestions for a narrow shank nut.

thanks

05 L322 Vogue

Some aftermarket wheels use a wheelnut more akin with a BMW car... No idea of the specs i, afraid

Have you measured the hole? only the earlier cars used 20 mm diameter nuts as opposed to the later cars that use 22.5 mm diameter nuts..... Failing that you'll have to ask Kahn and you know that's going to end in tears  Yesterday I couldn't spell Engineer... Today I are one!
Inventor of the 'Guide-o-Matic automatic wheel alignment tool'
Former long term L322 owner, Up/Down graded to a Classic Tractor!

this chap found them expensive as well,


 ... - .- -.




click link for ,

FORUM WIKI

HOW TO Ǝꓕ∀ꓕOꓤ PICS

workshop manual downloads are in our wiki

.

 Yesterday I couldn't spell Engineer... Today I are one!
Inventor of the 'Guide-o-Matic automatic wheel alignment tool'
Former long term L322 owner, Up/Down graded to a Classic Tractor!