Hi can anyone tell me where I can pickup a ignition feed for a camera monitor at the front and
a ignition feed at the rear for a reversing camera

do your ciggy sockets power off when you lock your FF?

if so, tap into those.. ... - .- -.




click link for ,

FORUM WIKI

HOW TO Ǝꓕ∀ꓕOꓤ PICS

workshop manual downloads are in our wiki

.

Hi Stan
thanks for your reply but the cig sockets are 12 volt permanant

you can change them to ignition feed by replacing the relay, do a search, theres info on that somewhere on the forum..

also, search dashcams or look in the wiki, it might give you some ideas.. ... - .- -.




click link for ,

FORUM WIKI

HOW TO Ǝꓕ∀ꓕOꓤ PICS

workshop manual downloads are in our wiki

.

Thanks Stan
I will look the info

The ignition feed in the rear is in the offside compartment.
If you look in the harness above the fuseboard you will find a1mm2 green/yellow cable. Thats it.
I would suggest tracing it to the rear of the car to find a siutable point for splicing in.
I strongly recommend you use the wire to feed a relay and take a feed for your camera from the rear fuseboard
The best way to get an ignition feed in the front is to use a piggyback fuse holder plugged into the front fuse-board into an ignition fed circuit.