Ok quick update
Did a battery reset and that seemed to work. Have a warning saying air suspension inactive and obviously suspension won't go up and down. Ran the IID and had a fault on eas 1/1 32 can bus fault
Is it worth repairing the compressor seal from bagpipesandy ?

Steve

Is there anybody there

" Ten Mrs Pugiewugies cutting square cut punts , they're low at the back and square at the front"
sorry your title reminded me of a drinking song from my rugby days
Have a go at taking the compressor out and put 12v into it and see how it runs , should tell you if its gubbed or saveable , but looking at the picture it looks like a leak from somewhere as well . 2008 MY Supercharged
Rimini Red / Jet
four zone climate
remote park heater
and no ugly kid windows.
magnus satis quod turpis satis

Thank you for the reply
Right went out to the RR today got in put the key in and message hdc inactive. Put the IID tool on and no faults regarding suspension. Pushed the down button on the dash and bingo suspension dropped down to entry height. Just one of those gremlins I reckon
I did do the live values in the IID and the reservoir compression was 180 psi. Had a bit of messing around up and down and psi dropped to 165
Do you think it's worth doing the pump repair kit ?

You have the opposite of me

Steverr, HDC inactive either low battery or ecu chain of commands error. Interesting no faults registered? YOu say it droped to access height OK, did it come back up to Normal/Off Road OK? It is believed that it should take @ 1.5 minutes to go from access to off road, best we have as a test for the compressor.... .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

Joe, I tried to go up to off road height but didn't wait long enough. I'll go check.
I always get the hdc whenever I don't use it for a few days... All fun and games ehhh
Ok update: goes up and goes down but is losing pressure somewhere. Went high to low back to Middle then wouldn't let me go any further. Checked the pressure on the IID and was 138psi.
So I'm thinking if if it was a strut leaking would it not come up as a fault on IID ?

Pressure will drop as you change height as its increasing the volume in the system as the air bag expands and the car goes up.

Check the pressure a minute or 2 after it has gone to top height and the pressure should have built back up as the pump will have kicked in.

If you keep sending the car up and down it will bleed loads of air out and will rise only on the pump which takes ages, and eventually overheat it.

Do stuff slowly, with the car running and don't keep going up and down.

Personally I would get the car in normal, run car for 5 mins, test the pressure. Run the car. Good excuse for a drive.

Get home check the pressure, should be same.

Put it up to top height, leave 5 mins with car running. Check pressure. Leave at off-road height, come back in morning. Before you run the car check the pressure. Should then be able to tell if you have a leak. There is nothing that can't be fixed with a hammer😜😜
FFRR 4.4 SDV8 Autobiography Santorini Black.
KIA E-Niro 4+
2021 Discovery 5 D300 MHEV commercial

thanks for the replies

axle wrote:

" Ten Mrs Pugiewugies cutting square cut punts , they're low at the back and square at the front"
sorry your title reminded me of a drinking song from my rugby days
Have a go at taking the compressor out and put 12v into it and see how it runs , should tell you if its gubbed or saveable , but looking at the picture it looks like a leak from somewhere as well .

Yes

Red/White wire +ve
Brown -ve

According to RAVE

If your getting 180psi in the tank then that's the right amount...

The pump will overheat pretty quickly going up and down a lot, it will then cut out until it cools, hence the lower pressure you found... wait and it will pump back up..... then

Leave it alone for a few hours, check the live values, tank pressure should be 180psi or thereabouts, drop it to access height, then turn knob twice so offroad height button flashes and time how long it takes...

Should be around 1 1/2 mins... if it's over two mins then it needs some work, try the new ring fix.... Pete
__________________________________________________
2014 L405 Autobiography SDV8 4.4 Loire Blue Ebony interior
2012 L322 Autobiography 5.0 Supercharged Ipanema Sand Sold
2011 L322 Vogue SE 4.4 TDV8 Baltic Blue. Sold
2002 L322 Vogue 4.4 V8 Epson Green (Fatty Offroader) Sold
-Click for Project Fatty off roader-

Joe90 wrote:

Yes

Red/White wire +ve
Brown -ve

According to RAVE

thank you

Hopefully fingers crossed all sorted. there was a noise like something was loose in the compressor. One of the 3 fixing bolts was a tad loose and vibrating the compressor.
I've put it into off road and took the pressure reading in live values. Leave it tonight then check in the morning.
Haven't a clue why it dropped !! Just one of those things that these do... But seems fine since the battery disconnect. Goes up and down like it should hopefully that's the end of this saga.... And on to the next....
Oh forgot to ask... Would anyone know what the heights should be in live values.
Mine are as follows
FL 110
FR 145
RL 160
RR 139
Steve