L322 non start and codes PO251, PO116 | |
Hi All
I'm having a few problems with my recently acquired 2011 L322 which (among other things I've posted on this forum) is a non runner. I have restricted performance displayed on the dash and the codes 'pending' in the ECU are
PO251 Injector Pump fuel metering Control 'A'
PO116 Engine coolant Temperature Sensor 1 Circuit range / performance
However oddly no confirmed and stored codes (this could be me deleting them, opps)
The car was a stolen recovered and was very low on diesel, showing a range of 30 miles. Therefore I've added some to take it out of the reserve.
Steps taken
- I plugged in my delphi scanner on OBD mode and determined
Fuel pressure - 1690 KPA or 16.9 bar
Coolant temperature reading 215 degrees at cold.
As the fuel pressure seemed low, given the code above and the non start I removed the high pressure pump and sent if off for diagnosis. Today I was told it tested fine, which I'm somewhat surprised about.
I also managed to start the car by cranking and squirting easy start down both intakes. Just enough for it to fire up and then die after stopping, so I certainly have a fuel pressure issue. Also I cracked open one of the unions on the fuel rail and have some fuel present.
Any advice would be great.
Thanks
|