Hi,
I've been having a mooch around the settings with the IIDtool.
My wife has MS and to get her in the car I pick her up and put her in the passenger seat. But now I have this tool, I'd like to see if I can get it to drop lower than the standard access height as she might be able to climb in herself if its low enough.
I just don't know how to do this and save it as a setting without affecting the other height settings.

Has anyone done this and can you share the how to please?

I've looked on a GAP IIDtool Q&A thread, on the Gap site and done a search but not found anything relating to this.
cheers
jake 2003 Range Rover Vogue 4.4 on Gas
1961 88" 2.25 diesel - George
Gone - 1997 3.9 V8i Discovery - Burt

Sorted, It was easy really.
went into height on the first screen.
pressed ⮟
selected access height then lowered by 15mm.
clicked ⮞
saved it, job done.

cheers
jake 2003 Range Rover Vogue 4.4 on Gas
1961 88" 2.25 diesel - George
Gone - 1997 3.9 V8i Discovery - Burt

Must try that on mine

Is this an overall height reduction (i.e. does it lower Normal and Off Road heights too) or does it affect only Access height? 2006MY 4.2 SC
BMW R1250 GSA Rallye TE
Triumph Tiger 1050 (sold)
1979 Pontiac Trans Am (sold)

its individual height settings on the 2002-2005 years and 'all modes' on the 2006 on wards... ... - .- -.




Y. O. L. O.
.

Thanks Stan 2006MY 4.2 SC
BMW R1250 GSA Rallye TE
Triumph Tiger 1050 (sold)
1979 Pontiac Trans Am (sold)

cracking bit of info on here http://www.gap-diagnostic.com/faq/

under air susp.
jake 2003 Range Rover Vogue 4.4 on Gas
1961 88" 2.25 diesel - George
Gone - 1997 3.9 V8i Discovery - Burt