Hi all I ha e a genuine l322 exterior design bumper. Had it all painted trims refurbed but there is a gap of about 15mm between the top of the tail pipe trim and the bumper is that normal? Current stable:
2006 BMW M6
2007 4.2 V8 S/C FF
Gone:
2002 4.4 V8 FF

Bump - surely someone has one - I have fitted now here is a pic but the gap at the top looks too much imo...

Are they the genuine exhaust trims ?
I have the bumper but couldn’t afford the £500 for genuine trims.
Couple of images taken from google

Click image to enlarge

Yours but easier to look at , hope you don’t mind

They look badly fitted to me 2021 L405 Vogue SE 4.4 V8 DIESEL ~ #17

Hi yes they are genuine - I know as they were heavily corroded so had to get them refinished.

What makes you say they are badly fitted because they are so low? I have checked on the powerful video on you tube and I have fitted exactly as it say - spacer trim then bolt... tried not using the spacer but because one space is slightly bigger each side it looked twisted... Current stable:
2006 BMW M6
2007 4.2 V8 S/C FF
Gone:
2002 4.4 V8 FF

It's not a good picture - but it looks like I could stick my fingers in the gap at the top and they look to be pointing slightly down. The bumper also looks a different colour 2021 L405 Vogue SE 4.4 V8 DIESEL ~ #17

I don’t think they look bad, maybe just need a bit of bracket bending ?
I’m not sure if the towing eye on the drivers side is the same on the later models that the design pack is from, my 04 has the design pack bumper and the bloody towing eye is right in the way of where I was making the drivers side exhaust trim. I wanted my exhaust to actually connect to the trim.
The bumper probably is just clean making the paint look a different colour and probably also has some pearl effect reflecting the light differently. A better photo in day light close to the exhaust trim wouldn’t go a miss either

You can see mine i think are they tighter fit?

Needs a wash and a better, lower down pic.
. Cheers, Greg
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
2011 Vogue SE 4.4 with lots of toys in Stornaway

Scotty have you got the metal or glass ones? They look higher than mine...

Everyone else gave it a clean what do we think now?

They look ok - but you are going to hate me - I prefer the standard bumper  2021 L405 Vogue SE 4.4 V8 DIESEL ~ #17

A tiny bit of me agrees but I have an exhaust system to fit and I didn’t want to be one of those guys (no offence if any here) who have four pipes hanging two inches below the bumper so I though I’d get this bumper as it’s oem and it sits a good 10cm lower and I can point the new boxes into the trims and no one will be the wiser other than the sound of course! Current stable:
2006 BMW M6
2007 4.2 V8 S/C FF
Gone:
2002 4.4 V8 FF

Danwilderspin, this are mine:

Dan, have you got the fibreglass ones or the genuine landrover ?