Advertise on fullfatrr.com »

Home > Technical (L322) > EGR restricted performance
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
Triumph72



Member Since: 11 Apr 2018
Location: Argyll
Posts: 39

United Kingdom 2010 Range Rover Vogue SE TDV8 Ipanema Sand
EGR restricted performance

Hi,

Going into restricted performance shortly after driving off, I found no difference in engine power,
the codes are

P045C-00 - Exhaust gas recirculation B control circuit - Low (2F)

P140E-21 - Exhaust gas recirculation position sensor C minimum/maximum stop performance - General signal failure - signal amplitude<minimum (28


I was just wondering if anyone knows what side of the engine the codes are for ?

I cleared the codes several times now but it always returns

Post #678497 22nd Nov 2023 1:18pm
View user's profile Send private message View poster's gallery Reply with quote
LASBAM



Member Since: 04 Apr 2017
Location: Reutlingen
Posts: 24

Germany 2007 Range Rover Vogue TDV8 Orkney Grey

Hi,

looks like your EGR Valve has a small defect with the electrical adjustment.

TWO ways to get it fixed
- Delete the EGR's with a Software patch and blind them mechanically
- Replace the defect EGR Valve unit (wO the Cooling)

Good luck! Current:
- 2006 RR L322 - 3.6 TDV8
- 2022 MB AMG GT BS
- 2020 Audi Q2

Past:
- Ferrari California 30
- 2018 Abarth 595 Competizione
- 2009 Porsche Cayenne Diesel
- 2010 MB E500 Coupé
- 2005 Porsche 996 Turbo
- 2002 Porsche Boxster 986 S
- 2001 Audi S8

Post #679261 1st Dec 2023 10:32pm
View user's profile Send private message View poster's gallery Reply with quote
Phoenix



Member Since: 16 May 2022
Location: Gone
Posts: 1631

United Kingdom 

...

Last edited by Phoenix on 23rd Dec 2023 11:34pm. Edited 1 time in total

Post #679262 1st Dec 2023 10:51pm
View user's profile Send private message View poster's gallery Reply with quote
Triumph72



Member Since: 11 Apr 2018
Location: Argyll
Posts: 39

United Kingdom 2010 Range Rover Vogue SE TDV8 Ipanema Sand

I finally got to use my Garage after my son removed his car.

Removed the inlet manifold to have a look at the EGR valve,
stripping it down I noticed that the valve was not closing properly,
it had built up rust on the shaft and wouldn't let the valve close.

I have emery clothed the shaft and cleaned the nylon cog, it's all back together now.

I have run the car for about 100 miles now and have not had restricted performance return

Hopefully it lasts and has saved me the cost of a new valve




Click image to enlarge


Click image to enlarge


Click image to enlarge

Post #680984 22nd Dec 2023 10:39pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT + 1 Hour

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
fullfatrr.com RSS Feed - All Forums


Switch to Mobile site