Hello, I am after a small but irritating grinding vibration on my car, which tipically occurs under light load can feel it on the floorplate, footwell,gas pedal. Especially when the torque converter has locked up already. My first go to will be the engine mounts but would do these as well on the photo below.

Anyone has done the replacemet for the engine mounts or these subframe insulators? are there any aftermarket insulators available for this, do you know?

The part number is KQD500060 and I didn't spot any after-market versions.

Thank you👍

The prices are horrendous if per insulator but perhaps not quite so bad if a full kit.
I would be surprised if they needed replacing though as I expect the engine and gearbox mounts would deteriorate much more quickly, especially the variable-damping engine mounts.

That will be per insulator, they won't come as a set.

Genuine Land Rover bushes are not cheap but they are very good and they do last.

When I rebuilt my old L322 in 2022 the rear subframe bushes were 75 quid each and there's 4 of them, each suspension arm bush was £50 and there was 14 of them. The car was totally transformed after I'd replaced every single one of them though.

David. 2002 4.6 Vogue SE - Alveston Red with Lightstone Leather
2012 Range Rover 5.0 SC Autobiography in Indus Silver with Jet/Ivory Interior
2012 Range Rover 4.4 TDV8 Autobiography in Baltic Blue with Sand Interior
2013 Range Rover Sport SDV6 HSE Black Edition in Santorini Black with Ebony Interior