ok height sensor clip ................what the helll
i have been trying for the last hour at least to reseat the clip into the new range rover height sensor (genuine one ) and well im at a loss is there some secret range rover magic in getting these clips to seat ????? because i was ready to drive the thing into the sea


anybody if you know what im doing wrong shout put ....thanks
will 2008 3.6 tdv8 range rover Vogue Stornoway grey - Parchment Leather

Clip? The electrical connector? The bracket can be a pain….

Some plugs have 6 pins and some have 3, make sure they match.

 2011 Range Rover Vogue SE 4.4 TDV8

Previous cars :
2003 Range Rover Vogue TD6
1999 Discovery Td5 ES
1995 BMW M5 3.8 6 speed
1992 Range Rover 3.9 Efi Vogue
1992 BMW M5 3.8
1988 BMW 735i SE
1989 Ford Sierra XR4x4 2.9i
1981 Ford Fiesta Supersport

yea the electrical connector............got the old sensor off ,new one on but the connector is another thing 2008 3.6 tdv8 range rover Vogue Stornoway grey - Parchment Leather

So you can’t get the connector to go into the new height sensor?

Make sure they both have the same number of pins as i imagine they won’t connect otherwise. Did mine over a year ago so can’t remember exactly, but I don’t think that was the hard bit for me, can’t remember if you have to press a clip to push it on, but don’t think so. 2011 Range Rover Vogue SE 4.4 TDV8

Previous cars :
2003 Range Rover Vogue TD6
1999 Discovery Td5 ES
1995 BMW M5 3.8 6 speed
1992 Range Rover 3.9 Efi Vogue
1992 BMW M5 3.8
1988 BMW 735i SE
1989 Ford Sierra XR4x4 2.9i
1981 Ford Fiesta Supersport

yea 3 pin ,there are clips to hold connector secularly on to the sensor .it just wont clip in going to have a another go tomorrow(depending on weather ) 2008 3.6 tdv8 range rover Vogue Stornoway grey - Parchment Leather

Yes, best to attack it again tomorrow, snow permitting. Save getting too annoyed with it. Did you get a genuine one? Though should still fit. I think one side may have curved edges so it will only fit one way, but you will be beyond that stage I imagine…. Can’t think of anything else… sorry…

 2011 Range Rover Vogue SE 4.4 TDV8

Previous cars :
2003 Range Rover Vogue TD6
1999 Discovery Td5 ES
1995 BMW M5 3.8 6 speed
1992 Range Rover 3.9 Efi Vogue
1992 BMW M5 3.8
1988 BMW 735i SE
1989 Ford Sierra XR4x4 2.9i
1981 Ford Fiesta Supersport

Check the orientation, they only fit one way. Kevin
2012 L322 Westminster 4.4 TDV8
1999 P38A 4.0 SE - Sold

They are not easy to remove and I had one that was not locked in properly which caused an intermittent adaptive dynamics fault . I blasted out the socket and plug with WD40 and got it to latch which not only resulted in no more faults but also a much smoother ride...... 2012 TDV8 Vogue (L322)

Yea genuine Range Rover part ,the old one was a bit to get off contacts cleaned with electrically cleaner,the contact will slid onto sensor but just won’t go in far enough for clips on the side to engage and hold in place 2008 3.6 tdv8 range rover Vogue Stornoway grey - Parchment Leather