Can anyone confirm that I did this correctly. I am getting the solenoid click but, the engine doesn't turn over at all.

Red thick wire - connected to 13mm post

Yellow and black wire - connected to 10mm post

Green and black wire - connected to 8mm post

I ask ChatGPT and it seem to think I should connect both Yellow and Green wire to 8mm post and nothing to 10mm post. I feel a bit silly for not looking carefully at the wires when I disconnected it before changing starter.

Thanks!

I'll answer my own question. That wiring is correct. It turned out that my battery was so badly damaged, that it wouldn't turn over, even with a booster pack attached, which was confusing me.

Also, chatGPT suggested swapping relays to try to diagnose the problem. I was a bit confused, since the relays are different colors, but, in the infinite wisdom of AI, it said that if the pins lined up, it would be fine to swap... WRONG! I had smoking wires within seconds and hopefully didn't mess up my electrical for good.

Ah, the next adventure will arrive soon.