Before any one says it yes i have had a look on wikki
I have to remove my rear bumper (2003 TD6 hse) is there anything special i have to watch out for and is there a sequance to follow

Cheers Paul.  Current Stable:
Range Rover 2003 TD6 HSE Alveston Red, Sand Leather
Ford Focus C-Max silver 2003
V/W transporter Blue 1995
Yamaha XJR1300 Yellow 2002
Kawasaki ZX7R Green 1998
Honda CBR 600 Black 1998
Yamaha RD125LC Mk1 Red 1986
Yamaha RD125LC Mk1 Blue 1986

 Present :2008 TDV8 HSE
Gone Audi A5 2.7TDI
Gone Discovery 3 HSE
Gone Mercedes CLK
Gone Range Rover 2.5 DSE

Cheers  Current Stable:
Range Rover 2003 TD6 HSE Alveston Red, Sand Leather
Ford Focus C-Max silver 2003
V/W transporter Blue 1995
Yamaha XJR1300 Yellow 2002
Kawasaki ZX7R Green 1998
Honda CBR 600 Black 1998
Yamaha RD125LC Mk1 Red 1986
Yamaha RD125LC Mk1 Blue 1986

Depends what you're doing. If like me you're fitting a tow bar, then you'll need the complete bumper off (not just the 'cover') The sides come off same as in the video, but rather than taking off the cover via the 8mm bolts, leave these in, and remove the whole bumper by taking of the 8 nuts inside the spare wheel well (4 each side - if I remember correctly 17mm) and don't forget to unplug the sensors - the plug is below the o/s/r light, behind the bumper.

Thanks again is it realy as simple as it sounds lol  Current Stable:
Range Rover 2003 TD6 HSE Alveston Red, Sand Leather
Ford Focus C-Max silver 2003
V/W transporter Blue 1995
Yamaha XJR1300 Yellow 2002
Kawasaki ZX7R Green 1998
Honda CBR 600 Black 1998
Yamaha RD125LC Mk1 Red 1986
Yamaha RD125LC Mk1 Blue 1986