TD6 '02 FFRR Front Air Spring Removal and Refit |
 |
| TITLE |
+ |
- |
| FILE NAME |
+ |
- |
| DATE |
+ |
- |
|
|
05 - Actually removing the Drop Link – 425 viewsTo remove the link from the mounting, you need to lever the ARB down to release the pressure, push it out, then gently raise your lever and remove
|
|
06 - Removing the Nuts on the two bolts at the lower end of the strut – 386 viewsThese guys are on super tight, see the home made extension bar (knocked up from trampoline bits) to get enough leverage. You need a 22mm deep socket to undo these.
|
|
07 - Close up of Lower nut removal on strut – 416 viewsAt this point I decided to support the hub from below with some wooden blocks to stop the susnsion moving downwards when force was applied to remove nuts and bolts. I chose not to remove the track rod end as recommend in RAVE.
|
|
08 - Tight Bastard! – 430 viewsThe upper bolt came loose as I undid the nut, but the lower one was jammed solid. Could just get it to turn using my super extension, but then it broke the 1/2 inch extension bar. With nut on, a clump hammer was brought into play, but this wouldn't shift it either. Looking like destruction will be necessary as I don't have welding torch to get some serious heat focused on it.
|
|
09 - The tight one! – 449 views
|
|
01 - Wheelnuts loosened before jacking – 210 viewsI followed workshop manual instructions for jacking, using the "customer jacking point to get the car up in the air, then an axle stand under the front subframe just to the rear of the wheelarch. You'll see where in later pictures. I left the trolley jack in place, under slight pressure for safety.
|
|
02 - The offending article – 356 viewsYou need to unclip the brake hose and the ABS sensor wire from the bracket and also release the ABS sensor wire from the clip on the other side. Now you are supposed to deflate the airbag, but as mine was already flat there was no need. I found if I moved the suspension up and down the car would start trying to fill it with air, so disconnected the battery to stop this happening. Will cover deflation elsewhere.
|
|
03 - Airbag fully deflated - there's a hole in it! – 368 viewsThe hole is about 3cm from the bottom or the bag on the left. We'll get a closer look once i have the strut off.
|
|
04 - Remove the Anti-Roll Bar Link – 422 viewsThis is all made to sound easy in most of the instructions I have seen - not so. You will need an 18mm deep socket to undo the nut, but also a 18/19mm open ended spanner which you slide up the back of the mounting point onto the flattened edges of the knuckle to hold it whilst you undo. You will then find the thread well and truly stuck in the mounting because of the pressure from the anti-roll bar
|
|
28 - Undo the Airline Connection – 321 viewsYou need a 12mm open ended spanner for this. Keep the airline pushed in while you undo it. It won't feel like you are doing anything, then suddenly it will be free.
|
|
29 - Airline with Connector removed from Air Bag – 335 viewsDo not remove the connector from the airline, if you do, you are likely to increase the chance of leaks when refitting
|
|
30 - Air Bag and Strut finally removed from vehicle! – 324 views
|
|
|
|
