fullfatrr.com Wiki > Service Reset Detailed Instructions
 
(Difference between revisions)
(→2) Procedure to check/reset service status – Date counter)
(→1) Procedure to check/reset service status – Distance counter)
Line 9: Line 9:
*Keep reset button pressed for approximately 5 seconds until the LCD displays ‘RESET SIA’. The distance to service (e.g. 2150 miles) and the service type (e.g. Inspection/oil service) will be displayed.
*Keep reset button pressed for approximately 5 seconds until the LCD displays ‘RESET SIA’. The distance to service (e.g. 2150 miles) and the service type (e.g. Inspection/oil service) will be displayed.
*Has the ‘Reset Distance’ limit been reached or exceeded?
*Has the ‘Reset Distance’ limit been reached or exceeded?
-
: NO - Follow instructions in section 2 below
+
:'''NO''' - Follow instructions in section 2 below
-
: YES - Follow ‘Reset Distance Counter’ instructions below
+
:'''YES''' - Follow ‘Reset Distance Counter’ instructions below
==Reset Distance counter procedure==
==Reset Distance counter procedure==

Revision as of 22:38, 6 December 2010

Service light reset – Land Rover

The procedures described below are relevant to the following European specification models:

Range Rover L322 2002 to 2004

Contents

1) Procedure to check/reset service status – Distance counter

  • Switch ignition OFF
  • Keep reset button pressed for approximately 5 seconds until the LCD displays ‘RESET SIA’. The distance to service (e.g. 2150 miles) and the service type (e.g. Inspection/oil service) will be displayed.
  • Has the ‘Reset Distance’ limit been reached or exceeded?
NO - Follow instructions in section 2 below
YES - Follow ‘Reset Distance Counter’ instructions below

Reset Distance counter procedure

  • Press and hold left instrument reset button for 5 seconds. ‘RESET’ will begin to flash on the LCD display.
  • To reset distance the left hand button should be pressed before the ‘RESET’ message has flashed 5 times
  • The LCD will display ‘END SIA’. Switch ignition off

2) Procedure to check/reset service status – Date counter

  • Press left instrument panel reset button once
  • The LCD will display ‘RESET SIA’ followed by the service due date.
  • Has the ‘Reset Date limit been reached or exceeded?
NO – Press the left instrument button once. The LCD will display ‘END SIA’ to indicate the service interval check/reset procedure has been cancelled.
YES - Follow ‘Reset Date Counter’ instructions below

Reset Date counter procedure

  • Press and hold left instrument reset button for 5 seconds. ‘RESET’ will begin to flash on the LCD display.
  • To reset distance the left hand button should be pressed before the ‘RESET’ message has flashed 5 times
  • The LCD will display ‘END SIA’. Switch ignition off
Retrieved from "https://www.fullfatrr.com/wiki/Service_Reset_Detailed_Instructions"