Home > Maintenance & Mods (L322) > Upper tailgate wiring loom |
|
|
Cam-Tech-Craig Member Since: 04 Aug 2011 Location: Gloucestershire Posts: 16180 |
Just unplug everything, feed the wires out and then refit the new one... Feed your existing loom back through and re-plug it all back in
|
||
5th Mar 2015 10:01pm |
|
Welshdragon Member Since: 20 Jan 2012 Location: here and there...but not where I should be Posts: 1898 |
Thanks Craig
|
||
5th Mar 2015 10:14pm |
|
mjdronfield Member Since: 04 Nov 2011 Location: Derbyshire Posts: 7641 |
I had mine changed and painted by a Bodyshop.
|
||
5th Mar 2015 10:35pm |
|
Welshdragon Member Since: 20 Jan 2012 Location: here and there...but not where I should be Posts: 1898 |
|
||
5th Mar 2015 10:45pm |
|
northernmonkeyjones Member Since: 24 Mar 2012 Location: derby Posts: 8479 |
when you pull the loom out is it possible to pull a cord through attached to the old loom to make pulling the new one back through easier? There is nothing that can't be fixed with a hammer😜😜
|
||
5th Mar 2015 10:57pm |
|
Cam-Tech-Craig Member Since: 04 Aug 2011 Location: Gloucestershire Posts: 16180 |
Two more tips WD... Before refitting, fill it with wax oil Secondly, when you remove the strip above the numberplate (as your wanting to spray and reuse yours) be careful as there is a manufacturing dimple in the centre so they tend to SNAP in the middle whilst removing them sir |
||
6th Mar 2015 12:11am |
|
Cam-Tech-Craig Member Since: 04 Aug 2011 Location: Gloucestershire Posts: 16180 |
Stainless steel welding wire is always good |
||
6th Mar 2015 12:12am |
|
Welshdragon Member Since: 20 Jan 2012 Location: here and there...but not where I should be Posts: 1898 |
Thank you sirs, will let you know how I get on If it dont work.......burn it!
|
||
6th Mar 2015 10:27am |
|
|
All times are GMT + 1 Hour |
< Previous Topic | Next Topic > |
Posting Rules
|
Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis