co-incidently i did the same......[tuesday and wednesday]

son fitted the lower arms and kwik-fit did the hunter alignment ....kinda cool watching them adjust the settings on the tv screen in the reception. ... - .- -.




click link for ,

FORUM WIKI

HOW TO Ǝꓕ∀ꓕOꓤ PICS

workshop manual downloads are in our wiki

.

Replaced my lower bumper bar on my 2012 Westie.

I won’t be doing that again in a hurry. Awful job

Got a nice new set of Pirelli Scorpion Verde 275/45R/21s fitted - hope they’re good for the claimed 65k miles, wouldn’t want to be paying that amount too often. L322 TDV8 4.4 - current
L322 TD6 - sold
Disco 2 TD5 - sold
Suzuki Grand Vitara XL7 - sold
Mitsubishi Pajero 2.8 - part ex'd
Hyundai Santa Fe 2.0 td - sold
Mitsubishi Pajero 2.8 - sold

In the last couple of days, got the car back after a small bump, see pics, bumper off, one new parking sensor, one new bumper mounting bracket, wing straightened out and some new paint. The other car a VW Passat needed new front bumper, new right front wing and drivers door The hire car I was given was a new 1.3 (turbo ) Nissan Qashqai, neat looking but very floaty and 'crashy' over bumps, it was horrible

First accident I have caused since I started driving

Full front suspension kit fitted today purchased from advanced factors nearly a year ago, just haven't had the time or energy. The ball joint in the hub is a bastard to smash out. Glad that's out the way. Also own a 1976 Land Rover 101 3.5 V8.
Previously owned 1991 Range Rover Vogue 3.9 V8.

Replaced the battery as in the last few days I have had on a few occasions a plethora of warning lights come up on the dash, relating to hdc, emergency brake assist, airbags etc.

The current battery was 4 years old so thought that it might be starting to fail. Only time will tell if its fixed the issue or there is an issue else where.

596 miles yesterday pulling a 22 ft long tri axle. 8’4”high by 7’1” wide.
Cumbria down to RAF Little Rissington, Loaded up an aeroplane, Throught the lanes of the Cotswolds and across to east Cambridgeshire to drop off AC, then back up the A1 to cumbria.
21 mpg ( it’s a barn door on the front) 19 hour day and no aches when I got home.
Harry Metcalf is right, the L113 is the most imperious tower , bar none.

give the inside a good clean....well good enough until I pick up a wet vac

Changed the 'Napa' AGM battery for a decent Varta G14/A5 as I've had a couple of non-start occasions recently after some limited battery usage without the engine running.

Hopefully it'll perform better - just 10 minutes of the radio on was bringing me a low-battery warning and manual vent wouldn't run for more than a few minutes last time I used it. 2012 (L322) 4.4TDV8 Vogue SE, RSE, Fuji White over Arabica.
Previous V8s: BMW 645Ci, P38 4.6, P38 4.0, Merc CL500
Previous others: Honda x1, Volvo x7, Rover x6, BMW x6, Ford x1, Mercedes x2, Skoda x3, VW x2, Renault x2, Citroen x1, Mazda x3, Nissan x1, Audi x3, Kia x1, Fiat x4, Subaru x3, Austin x2, Triumph x2, Jeep x2, Hyundai x2, Lexus x1, Mitsubishi x1, Saab x2... and some others I've forgotten!

Just finished 1300 miles in 3 days including 3 channel crossings, the old girl hasn’t missed a beat and has to the best car to do these big miles in. No aches or pains now I’ve finally arrived in the Dordogne for the week.
Cant believe how smooth the roads are in France, makes these cars feel like they are just floating down the road. Amazing. 2013 SDV8 4.4 Vogue SE Aintree

Changed the rear discs and pads

I have been putting in some miles on the 322 recently.....

Got in mine for the first time in 3 weeks and realised I probably need a new battery. TBF it’s an LR battery in there so may well be original 😬

Went for a drive through the Devils staircase in Wales, (Abergwesyn), nicest drive I have had in a long time, not a soul on the road not in front or coming towards me, just nice to give the old beast a bit of a workout over some winding roads.

Off on our first big trip in the car tomorrow and this evening the right front splash guard for non reason (well a bit of electolisis between the aluminium casting and steel guard!) departed company with two of its fastenings and sounded like a bucket of nails shaking around! Didn't have the right socket to remove the caliper so have just butchered the splash guard off with tin snips! Another job to do in a week when we are back!! Fingers crossed that the only issue we have in the next 10 days of motoring..... Current
2011 4.4TDV8 VSE
1972 MGBGT
Gone
2004 Discovery Landmark 2.5D
2003 Freelander TD4 SE