Hi Folks,

If anyone has done this - can they tell me if

1. once the wing tabs are cut off (to allow the lights to fit) is it absolutely necessary to "stick" the inner/outer wing together again.

2. If I don;t replace the bumper crash bar - is it easy to modify the old on so the fogs fit. I've got a price from Dan for a new one but trying to avoid paying out too much.

ps Dan - I'll pm you re the washer pump. (Thx)

Thanks
Ash Ash
------------------------------------------------------
2016 SDV8 AB

i gather that you've read the wiki 'how to' Ash, is this not in there? ... - .- -.




click link for ,

FORUM WIKI

HOW TO Ǝꓕ∀ꓕOꓤ PICS

workshop manual downloads are in our wiki

.

I did Stan,

1 suggest body glue (so I just bought some metal epoxy) and another suggests making alluminium angles and rivets.

The second suggest you need to adjust the crash bar to accomodate the fogs but no mention of if it's easy. I gather its real steel as its a crash bar so not that easy to cut I would suspect.

Wondered if there was any comment from anyone that's already done the mod.

I've got most of the bits and trying to pluck up the courage to do it.!  Ash
------------------------------------------------------
2016 SDV8 AB

This should help

http://www.fullfatrr.com/forum/topic9699.html?highlight=facelift

 Present :2008 TDV8 HSE
Gone Audi A5 2.7TDI
Gone Discovery 3 HSE
Gone Mercedes CLK
Gone Range Rover 2.5 DSE

someone that will know is Craig [cam-tech-craig]...ping him a pm Ash.. ... - .- -.




click link for ,

FORUM WIKI

HOW TO Ǝꓕ∀ꓕOꓤ PICS

workshop manual downloads are in our wiki

.

Will do - Thx Stan Ash
------------------------------------------------------
2016 SDV8 AB