Started my conversion yesterday, had the grinder out I cut the tabs off then had to take a bit off below the tabs, but still the new lights fouled on the wings had to loosen the wing screws to get the shut lines to look right. then when I went to refit the bumper I find the ally bar that the new bumper fixes to does not line up with the lugs on the new bumper, does this have to be replaced?

See here
http://www.fullfatrr.com/forum/topic9699.h...conversion

You need to mod the bar, straight forward job.

Cheers Paul.

Anybody need the plugs to change the headlights I have a spare set bought from Powerfull uk.

Have you wired the lights using Powerful diagram?

Not yet only got them last week, But when I checked the box with the headlights in that I bought there was a set of plugs in there.

When you get round to wiring them, check pins 5 and 6 on the plugs.

You need to have a connection on both of these otherwise your xenons wont flip to main beam.

PM me when your going to do it and i will explain further.

Good luck.

Oh crap they say its ok just to wirer them from there instructions.

Do you know anybody that will do the wiring in the Derbyshire area?

Instructions are incorrect, i have spoken to them.

I'm not happy doing the wiring so I will try and find someone to do it for me. I'm not good with electrics.

Bozzy1954 wrote:

Anybody need the plugs to change the headlights I have a spare set bought from Powerfull uk.

Ill have them please...

There yours I paid £85 for them I think there worth £60.

Ill send you a PM

Hi, Where can I get fog light plug connectors, they look different on the knew bumper.