Yeap, the drivers side looked ok for me, with no signs of repair before (will be checking when a little warmer) but the one I did a quick fix on has defo been done before with the tape that was on it. I think the heat from the engine and then the cold weather has done it.

I'm making 2 new looms to Make, I will use silicon wire, no cracking ,

Will need to take a look at pics and vids before I try anything like that

Newbie here and this post has been very helpful except for one thing - has anyone ever repaired this loom on a 2010 RRS S/C ? I cannot for the life of me find the location under the bonnet of the top mount where this harness is?

Can anyone shed any light please? I have googled and read so many posts for the past 2 hours, yet I am still at a total loss as there isn't a single thread or post relating to the 2010 RRS

Any help would be HIGHLY appreciated

that's cos you're on the wrong forum, try our sister site, link at bottom of the main page. ... - .- -.




Y. O. L. O.
.