Hello,

Just got car back from dealer and noticed that on front driver's side wing, the piece of square plastic/ colour coded trim at the bottom of the wing (between the wheelarch and the driver's door) seems slightly 'dented'/ pushed in.

Paintwork is fine/ best way to describe it is like a en empty plastic bottle that gets pushed in a bit.

How is the trim removed?

Hoping I can heat the piece up with a hairdryer and/ or push it back out by hand without bothering anyone else about it.

Please/ thanks

Open door, look for large white or black plastic fastener below door hinge. Pop this out with a large screw driver.

You may then need to remove screws for front mudflap if you have them.

Then at bottom of side vent and edge of wing, loosen bolt to release. Will be a fiddle to refit.

Search on here for side vent removal (wiki) for images. .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

check this

at 0.36 sec

Brilliant. Cheers

They just pull off if no mudflaps from door edge....