Comes up on start up, turn on sidelights, get out and check, all working.

I have LED sidelights up front, been there for years, never given a problem before.

On ignition off get "FRONT SIDELIGHT"

Has one or both of my LEDs had its day ? .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

Joe its the "Bling" warning mate....

those errors normally come up when theres a faulty bulb or a non-canbus bulb fitted..i suspect that one or both bulbs have burnt out their canbus circuit....or the bulb just needs re-seating. ... - .- -.




click link for ,

FORUM WIKI

HOW TO Ǝꓕ∀ꓕOꓤ PICS

workshop manual downloads are in our wiki

.

+1 for ^

Thanks guys, I'll have a play tomorrow .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

Had a chance to have a look. It was both LEDs, whether they have both gone at once, or it took both to trigger the fault, but see from the picture where the problem was:

Cheap Chinese crap! Let this be a lesson to you all as to how they can melt when they use sub standard electronics... Sorry Joe90 to cut accross your thread but have seen a few interior bulbs do this lately and would hate for one of our members FF's to go up in flames!

i've brought a fair amount of leds/smds and nearly all get dry joints within months of use, but a quick dabble with a soldering iron and they work ok again... ... - .- -.




click link for ,

FORUM WIKI

HOW TO Ǝꓕ∀ꓕOꓤ PICS

workshop manual downloads are in our wiki

.

Stan recommended them (the ones in the photo)

and DMRR the ones I just bought. What is your preferred solution, Craig ? .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

i did


i do like these

http://www.ebay.co.uk/itm/2X-T10-501-W5W-C...27d8eab840


 ... - .- -.




click link for ,

FORUM WIKI

HOW TO Ǝꓕ∀ꓕOꓤ PICS

workshop manual downloads are in our wiki

.

The bulbs I used are very bright, almost brighter than the H7s in my foglight DRLs, don't give a canbus message, but blink every 20 seconds or so (this must be the canbus test) .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

you can switch off the hot monitoring with an IIDTool, but you probably knew that already.. ... - .- -.




click link for ,

FORUM WIKI

HOW TO Ǝꓕ∀ꓕOꓤ PICS

workshop manual downloads are in our wiki

.

Always too embarrassed to ask what hot and cold monitoring is  .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

thats when the ecu checks to see if the bulb is ok..cold on start up and hot whilst engine running..
so if you have non-canbus bulbs it'll throw up an error. ... - .- -.




click link for ,

FORUM WIKI

HOW TO Ǝꓕ∀ꓕOꓤ PICS

workshop manual downloads are in our wiki

.