{EDIT} Oops for 3.6 TDV8

Option - 6 x silicon hoses on eBay (there are six hoses in all!)

LINK

DrRob wrote:

Great! Learning lots. Appreciate all the help and advice on here

Looks like mine has had the mod done already with 4 new hoses

 Gone to a good home: 2011 4.4 TDV8 Vogue SE Buckingham Blue with Ivory and clear glass = "Rory"
2025MY Defender D350 90 in Silicon Silver on coils
1974 Series 3 Lightweight = "Millie"
Many, many other Landies over the years
I use www.glenrands.co.uk Great independent specialist!
--------------------------------------------------

Baltic Blue wrote:

The original 4 hoses are very soft pliable rubber, but the replacements are much tougher.
They cost approx £100 for the 4 with new jubilee clips.

These are the replacements on mine.

Mike.

IIRC the donut needs to come out to change the 11MY 4.4TDV8 hoses. It's not a difficult job but there are a few things to take care around.

Hoses can be replaced with silicon ones I believe.

Search on the forum for the donut hoses, MAP cleaning and silicon hose replacement. I don't think the Wiki has a how to as such but there are several threads on here where the work has been done. If I have some time later I'll search about.

Have you bought a 2011 4.4 or are you helping someone as your profile reads a 2007? Just curious.  Cheers
Richard

(there are no such things as an ordinary FullFat, an ordinary cat or too many tools)
2011 TDV8 Vogue Santorini Black
Gap IIDBT

Thanks, you’re right the donut does need to come off. Fiddle little blighter it is too!

Found a link to a how to in the end:
https://www.fullfatrr.com/forum/topic49730.html?highlight=plenum

Now to sort some silicone pipe out, will have to wait til tomorrow as nowhere local open that stocks it.

Good spot on the profile, updated now, albeit Indus Silver not an option maybe rare!?

Any other hoses worth replacing with silicone while I’m in there?

Cheers

Matt

Not too sure about the availability of other silicon hoses, but someone may be along with that info.

While it's apart, clean the throttle body insode to make sure it will stay free to move (can cause the gearing to strip, then it's a new unit), the MAP sensor on the top of the donut inlet and clean the donut itself(cr***y job).

Have a good look at the turbo oil feed connection at the rear of the oil cooler, and perhaps change the two o rings for new vitol ones while you're in there. Details in a thread on here.

HTH Cheers
Richard

(there are no such things as an ordinary FullFat, an ordinary cat or too many tools)
2011 TDV8 Vogue Santorini Black
Gap IIDBT