Any GAP tool aficionados on here that can help with some settings the GAP tool can change such as remembering the last auto start/stop setting and the drivers assist settings?

Also is there a way to disable the seatbelt chime on an L460? "UNDERSTEER" ----is when you hit the fence with the front of the car.
"OVERSTEER" ------is when you hit the fence with the rear of the car.
"HORSEPOWER" ----is how fast you hit the fence.
"TORQUE" -----------is how far you take the fence with you.

I'd also be interested to know this.

There was a guy in birmingham that said he could turn off auto stop/start and the seatbelt chime but haven't been able to organise a trip yet and don't know how he would do it.

The annoying "door open" when engine on chime would also be a great thing to disable

does the L460 have all its bits in the rear right cubby like the L405?

if so , the setup might be the same and you can disconnect the signal wire to the capacitor or disconnect the aux battery if you have one.. ... - .- -.




Y. O. L. O.
.

A D300/D350 will have a 48V integrated system for stop-start. L405 D350 SE Carpathian Grey D5 19" rims

CCF Edits

MultiCAN-505 WalkAwayLocking set to Enabled
MultiCAN-807 Approach Unlocking set to Enabled

MultiCAN-733 Backlight Heartbeat set to Enabled

I'm in the US and we have the best part of having the Pixel and Matrix lighting features turned off because of the NHTSA not keeping up with the times on lighting safety technology.

Does anyone know the correct CCF edits to enable them to allow shadowing oncoming traffic and activate bending around curves along with highway mode?