Oops… no message. V8 or else ...

Thanks Fisha, that is realy helpful.
As yours is an SDV8 like mine which of the Maltings 4x4 Dunlop shock absorbers did you get. letters not necessarily in the right order

Just looked back at the order:

Dunlop Right Hand Rear Shock Absorber for Range Rover L405 - LR034266
Dunlop Left Hand Rear Shock Absorber for Range Rover L405 - LR034271

They both plugged in just fine, and zero errors or need to reset anything.

Only thing that annoys me was that my car always wants to self level downwards when jacked*, so when it came to removing the damper out, I had to faff with jacking the car to get enough clearance back.


Its blooming infuriating ... I'll need to figure out a solution, cause all the normal options of leave a door open etc just doesn't stop it. V8 or else ...

Thanks
Those were the ones I had settled on. letters not necessarily in the right order

A virtual beer to Fisha.
Job done.
The tip about undoing the bar made all the difference.
For those going to do it a few tips.
A 13mm ratcheting ring spanner makes undoing the bar easier and without that access to the outside front nut is almost impossible.
Slacken off the lower nut and bolt as soon as the wheel is off.
2 trolley jacks made it a lot easier.
There is absolutely no need to remove the rear seats. letters not necessarily in the right order

Great stuff. Was actually a relatively straight forward job in hindsight. V8 or else ...