Advertise on fullfatrr.com »

Home > Search
Search found 10 matches

Topic Starter Message
 2011 5.0 N/A no crank after engine replacement
peanutpckrupper

Post6th May 2025 8:48pm
Forum: Technical (L322) · Replies: 13 · Views: 628 · Subject: 2011 5.0 N/A no crank after engine replacement
The sensors were plugged in, but I didn't have the center airbox installed and hooked up to the throttle body. Running all good now! Time to reinstall everything and take it out on the road for the fi ...
 2011 5.0 N/A no crank after engine replacement
peanutpckrupper

Post6th May 2025 8:43pm
Forum: Technical (L322) · Replies: 13 · Views: 628 · Subject: 2011 5.0 N/A no crank after engine replacement
Turns out this is one of those cars where you need to have the airbox fully installed for it to run Banging Head

So the gist of it is: Put it at least most of the way back together and step on the brak ...
 2011 5.0 N/A no crank after engine replacement
peanutpckrupper

Post6th May 2025 7:13pm
Forum: Technical (L322) · Replies: 13 · Views: 628 · Subject: 2011 5.0 N/A no crank after engine replacement
Well it kinda starts now but I didn't do anything different from before. Long crank, runs for a second or so then dies. I can rev it up just fine while it's running but it always bogs out after a seco ...
 2011 5.0 N/A no crank after engine replacement
peanutpckrupper

Post6th May 2025 4:27pm
Forum: Technical (L322) · Replies: 13 · Views: 628 · Subject: 2011 5.0 N/A no crank after engine replacement
It starts on starting fluid, I need to investigate the fuel system.
 2011 5.0 N/A no crank after engine replacement
peanutpckrupper

Post6th May 2025 3:03pm
Forum: Technical (L322) · Replies: 13 · Views: 628 · Subject: 2011 5.0 N/A no crank after engine replacement
dhallworth you're my hero, I've moved on to a crank no start now. That's way easier to investigate.
 2011 5.0 N/A no crank after engine replacement
peanutpckrupper

Post6th May 2025 2:39pm
Forum: Technical (L322) · Replies: 13 · Views: 628 · Subject: 2011 5.0 N/A no crank after engine replacement
Gotcha I see the edits. I used the wiring harness from the original engine and the engine does crank if I apply 12v to the starter signal wire but still does not start.
 2011 5.0 N/A no crank after engine replacement
peanutpckrupper

Post6th May 2025 2:33pm
Forum: Technical (L322) · Replies: 13 · Views: 628 · Subject: 2011 5.0 N/A no crank after engine replacement
I didn't disconnect the braking system, but I'll try pumping up the brakes to see if that helps. Thanks!
 2011 5.0 N/A no crank after engine replacement
peanutpckrupper

Post6th May 2025 2:28pm
Forum: Technical (L322) · Replies: 13 · Views: 628 · Subject: 2011 5.0 N/A no crank after engine replacement
Replaced the engine in my 2011 due to timing chain failure and now I have a no crank condition. When I press the start button the ignition will come on sometimes for 1 second then shuts off, sometimes ...
 Torque Converter Bolt Removal
peanutpckrupper

Post27th Apr 2025 6:41pm
Forum: Technical (L322) · Replies: 0 · Views: 296 · Subject: Torque Converter Bolt Removal
Just wanted to share the setup I used for removing the torque converter bolts from my 2011 N/A 5.0 since I didn't see anything like this out there.

I went through the wheel well after removing the ...
 Welcome to fullfatrr.com - introduce yourself here!
peanutpckrupper

Post27th Apr 2025 6:20pm
Forum: General · Replies: 4417 · Views: 1537340 · Subject: Welcome to fullfatrr.com - introduce yourself here!
Hello everybody! Joined up here to learn about as well as share some info on my auction bought 2011 Range Rover HSE!
 
All times are GMT + 1 Hour

Jump to  
Page 1 of 1



Site Copyright © 2006-2025 Futuranet Ltd & Martin Lewis
fullfatrr.com RSS Feed - All Forums


Switch to Mobile site