I think that the two are connected to my swapping the panel around the gear selector which meant I had to swop the switch pack from my brunnel grey panel to the painted panel which had no electrics. The switches have positive click give no response when used. All wires are connected as I did double check.

I can get the transmission to engage Low if I hold either switch as I plug in the connector so I think it must be a problem with the switches but would appreciate thoughts/comments.

Car drives fine in High Ratio and everything works except for the HDC and switching to Low Range. [/img] There is a difference between knowing your sh!t and knowing you're sh!t

2005 Registered 2006 MY 4.4 AJV8 Range Rover Vogue

Any idea if this is likely to just be a faulty switch or something more complicated. No obvious error codes when scanned on iid. There is a difference between knowing your sh!t and knowing you're sh!t

2005 Registered 2006 MY 4.4 AJV8 Range Rover Vogue

Assume it was all working OK before the panel swap?

The two are linked together looking at the wiring diagrams (ZF) so suggest you run back through all the connections again.

A battery reset might sort this out? .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

New central control panel and HDC and Low Range working again. There is a difference between knowing your sh!t and knowing you're sh!t

2005 Registered 2006 MY 4.4 AJV8 Range Rover Vogue