Just had a warning show up with the above, suspension fault when cornering, any ideas what it could be, apart from expensive !!
Thanks

You have this topic under L405 but your profile has an L322 listed.

One's expensive to repair, the other's very expensive to repair!

Mike

very true Mike...  ... - .- -.




Y. O. L. O.
.

Sorry not updated profile
I’ve got both, 322, and a 405.
That’s cheered me up no end !!
Could it just be a sensor fault?
The car seems to be driving ok

OP....find anything? 2014 FF Autobiography 5.0 SC
2008 FFRR (sold)
2008 BMW M5

Have you checked your ACE fluid level?

I recently had to replace the ACE pipes as they had corroded...

Hi,
I am new to the board. Just wondering if replacing the ACE pipes is something a reasonably experienced weekend mechanic could handle at home?

2016 L405 5.0 SC with C1119-09 (Permanent Hydraulic Pressure) error code and red suspension fault message to "Stop Safely Stop Safely Stop Engine. My ACE pipes are pretty rusty, so am thinking that is causing the pressure issue as I dont have any other error codes.

Thanks for the help and add



[/img]

Last edited by NoHandSignals on 29th Aug 2023 12:30am. Edited 1 time in total

To do the job with original pipes you need to remove the rear subframe, download the Workshop Manual from the WIKI (link above right) It is a lot of work but doable for a home mechanic... I did hear rumours that the dealers charge up to £7,000 for doing it but that's probably a bit excessive...

Just a thought, if you removed both ends, worked out a new route for the pipes and got a flexible hydraulic hose made up it would be considerably quicker and cheaper than using new pipes which will just rust again.... Maybe it's possible....

The other answer is to rip the whole sway bars off and replace with the normal ones they fitted to the V6 diesel over here...!!

Never tried the above but in theory it should work.... maybe....!! Pete
__________________________________________________
2014 L405 Autobiography SDV8 4.4 Loire Blue Ebony interior
-Click here for Thread-
2012 L322 Autobiography 5.0 Supercharged Ipanema Sand Sold
2011 L322 Vogue SE 4.4 TDV8 Baltic Blue. Sold
2002 L322 Vogue 4.4 V8 Epson Green (Fatty Offroader) Sold
-Click here for Project Fatty off roader-

Thanks for the vote of confidence! I ordered the factory pipes today for both front and rear. Should be here in a couple weeks.

Hopefully for the rear I can drop the subframe a little and snake the new pipes over it? Don't fancy dropping it out completely... eek


Some sort of replacement pipe, or perhaps cut and join with a hydraulic joint could be an alternative if I choke on this! Thanks for the suggestion

The pipes are too intricately shaped, and the subframe too close to the floor to cut them and rejoin without dropping the subframe...

Thanks, Mickey. I thought that might be the case as the pipes sure do look very intricately shaped!

..definitely going to be a learning experience.

Mikey wrote:

The pipes are too intricately shaped, and the subframe too close to the floor to cut them and rejoin without dropping the subframe...

Good to know, cheers...  Pete
__________________________________________________
2014 L405 Autobiography SDV8 4.4 Loire Blue Ebony interior
-Click here for Thread-
2012 L322 Autobiography 5.0 Supercharged Ipanema Sand Sold
2011 L322 Vogue SE 4.4 TDV8 Baltic Blue. Sold
2002 L322 Vogue 4.4 V8 Epson Green (Fatty Offroader) Sold
-Click here for Project Fatty off roader-