Advertise on fullfatrr.com »

Home > Technical (L322) > 3.6 TDV8 Oil Cooler/Filter housing seal replacement
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
Jamiehol



Member Since: 26 Sep 2014
Location: Ipswich
Posts: 232
United Kingdom 2007 Range Rover Vogue TDV8 Stornoway Grey
3.6 TDV8 Oil Cooler/Filter housing seal replacement

It’s been a while since I’ve posted but I’m replacing the seal between the oil filter housing and block on my 3.6 TDV8 engine and I’m struggling to find the torque figures for the bolts that hold the housing down to the block.

I can’t see them in the manuals in the wiki, so just wondered if anyone happened to know what they should be tightened to?

Thanks,
Jamie
Post #725325 29th Sep 2025 12:14pm
View user's profile Send private message View poster's gallery Reply with quote
Red Hot one



Member Since: 09 Dec 2018
Location: Herefordshire
Posts: 229
United Kingdom 2009 Range Rover Vogue TDV8 Stornoway Grey

When I did mine I used 8Nm the reccomended m6 into aluminium setting.
Post #725335 29th Sep 2025 1:48pm
View user's profile Send private message View poster's gallery Reply with quote
Jamiehol



Member Since: 26 Sep 2014
Location: Ipswich
Posts: 232
United Kingdom 2007 Range Rover Vogue TDV8 Stornoway Grey

Thanks, I’d got as far as in the absence of anything else using a figure of 10Nm as that is what the M6 sump bolts are.
Post #725350 29th Sep 2025 5:12pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT + 1 Hour

Jump to  
<  Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2025 Futuranet Ltd & Martin Lewis
fullfatrr.com RSS Feed - All Forums


Switch to Mobile site